Improvised stationery division

Pocket Briefcase

Measure a wallet. Cut a tiny pad. Recruit a suspiciously short pen. Become the sort of person who can catch an idea before it escapes into traffic.

Fit the paper.

Measure the clear flat area inside your wallet. The workshop subtracts a safe margin and draws a cut guide. No premium executive stationery required.

Wallet width 90 mm

Wallet height 105 mm

Breathing room 6 mm

Cut paper to 78 × 93 mm. Stack 12 sheets for a pocketable first edition.

Tip: test one scrap sheet before cutting a stack. Wallets, like software estimates, may contain undocumented interior constraints.

Tap each station as you complete it. This is not complicated, but that has never stopped a respectable workshop from issuing procedures.

STATION ACutTrim 12–20 sheets to the workshop dimensions. Round the corners if you possess both patience and scissors.

STATION BBindStaple the top edge, or clamp it with a miniature binder clip. Keep bulk below trouser-annoyance levels.

STATION CAffixRoll duct tape into two sticky-side-out loops. Press the pad into a clear interior panel.

STATION DStowSlide a mini pen into a card pocket. Practise Jon’s advanced pen-only extraction manoeuvre.

A pocket system succeeds only if it is faster than “I’ll remember that.” Run the ten-second field test.

10.0

SECONDS TO CAPTURE

Your incoming thought

A game Nathan might invent from three household objects…

Wallet closed. Idea currently at large.

Inspired by Jon’s DIY International Pocket Briefcase aka David Allen NoteTaker Wallet, a four-ingredient rebellion against an $89 accessory.